Fire Station Mapping

Introduction

After we have created the fire station master, the next step would be to map the Districts, Sub-Districts, and ULBs with the fire stations. The two points that are very important to note here are:

  1. All the ULBs in the state may not have a fire department.

  2. Usually, only the larger ULBs in the state have a fire department that caters to that ULB at the same time to all the surrounding smaller ULBs and rural areas as well.

Data Table

Urban Area - Fire station mapping

Rural Area - Fire station mapping

Note: Data given in the above table is sample data.

Procedure

Data Definitions

Urban Area

Rural Area

How to fill data

Urban Area - Fire Mapping

  1. Download the data template attached to this page.

  2. Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.

  3. In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.

  4. Enter the district codes of all the districts where fire services are provided, in the ‘District Code Column’.

  5. Next, enter the ULB codes of all the ULBs within a particular district where the fire services are provided in the 'ULB Code Column'.

  6. Identify the fire stations that are serving each District - ULB combination and enter their name in the Fire Station column along with its code in the Fire Station Code.

  7. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Rural Area - Fire Mapping

  1. Download the data template attached to this page.

  2. Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.

  3. In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.

  4. Enter the district codes of all the districts where fire services are provided, in the ‘District Code Column’.

  5. Next, enter the sub-district codes of all the sub-district within a particular district where the fire services are provided in the 'Sub District Code Column'.

  6. Identify the fire stations that are serving each District - Sub District combination and enter their name in the Fire Station column along with its code in the Fire Station Code.

  7. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

Common Checklist

This checklist covers all the activities which are common across the entities.

Entity Specific Checklist

This checklist covers the activities which are specific to the entity.

Attachments

Configuration Data Templateconfiguration-data-fire-station-mapping.xlsx - 11KB

Sample Datasample-data-template-fire-station-mapping.xlsx - 11KB

Last updated

​All content on this page by eGov Foundation is licensed under a Creative Commons Attribution 4.0 International License.