Unit Rates

Introduction

Unit rates are also an important part of property tax. The property tax for a property is calculated on the area covered by the property. These unit rates could differ from ULB to ULB, Ward to Ward, Mohalla to Mohalla and then can be based on different parameters such as Road Type, Property Construction Type etc.

Data Table

Sr. No.Boundary Code*Boundary Name*Parameter 1*Parameter 2Unit Rate*

1

M001

Haldwani Mandir

PUCCA

< 12 m

1.50

2

M001

Haldwani Mandir

SEMIPUCCA

>= 12 m and <= 24 m

1.75

3

M001

Haldwani Mandir

KUCCHA

> 24 m

2.00

4

M002

Kali Mata Mandir Road

SEMIPUCCA

< 12 m

3.00

5

M002

Kali Mata Mandir Road

SEMIPUCCA

>= 12 m and <= 24 m

10.00

6

M002

Kali Mata Mandir Road

SEMIPUCCA

> 24 m

20.00

The data given in the table is sample data.

Procedure

Data Definition

Sr. No.Column NameData TypeData SizeIs Mandatory?Description

1

Boundary Code

Alphanumeric

64

Yes

The code of the boundary that is being used, depending upon the client's requirement it could be Mohalla or Ward but has to be from the data collected here

2

Boundary Name (In English)

Text

256

Yes

The name/description of the boundary that is being used for the classification. The names have to be from the data collected here

3

Parameter 1

Alphanumeric

64

Yes

This has to be the parameter 1 code on the basis of which the unit rates are being defined

4

Parameter 2

Alphanumeric

64

No

This is the second parameter(if available) on the basis of which the unit rates are being defined

5

Unit rates

Decimal

(5,2)

Yes

The unit rate

Steps to fill the data

  1. Download the data template attached to this page.

  2. Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.

  3. In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.

  4. Figure out on what boundary types are the property tax unit rates being defined and start filling that with its code and its name in English in the boundary code and boundary code name column.

  5. In case there are more parameters on which the unit rates are being classified such as road type, construction type is being classified, start making a different column for the same starting from parameter 1, parameter 2…

  6. Make sure you replace the column name from parameter 1 to the classification on which it is being classified.

  7. At the end fill up the unit rates column.

  8. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed once the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Sr. No.Checklist ParameterExample

1

Make sure that each and every point in this reference list has been taken care of

Checklist

Entity Specific Checklist

Not Applicable

Attachments

Configuration Data Templateconfigurable-data-template-property-tax-unit-rate-v1.xlsx - 9KB

Sample Dataconfigurable-sample-data-property-tax-unit-rate-v1.xlsx - 10KB

Last updated

​All content on this page by eGov Foundation is licensed under a Creative Commons Attribution 4.0 International License.