Pipe Size Types
Introduction
Water pipes are available in different sizes. Pipe size is a common parameter used for calculating water charges. The allotted pipe size for new water connections depends on specific service requirements.
Data Table
Sr. No.
Pipe Size*
UOM*
1
0.25
Inches
2
0.50
Inches
The data given in the table is sample data for reference.
Procedure
Data Definition
Sr. No.
Column Name
Data Type
Data Size
Mandatory
Description
1
Pipe size
Decimal
(2,2)
Mandatory
Value for Pipe size
2
UOM
Text
256
Mandatory
Unit of measurement for the pipe size value
Steps to fill data
Download the data template attached to this page.
Refer to the ‘Data Definition’ section of this document to understand the headers in the template sheet, their data type, size, and definitions.
Reach out to the person who shared the template for further details or to clear your doubts. Identify if the State/ULB has a provision for capturing pipe size for connections.
Enter the Pipe Size details.
Enter the corresponding UOM for the specified Pipe Size.
Go through the checklist to verify the data. Make sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist is a set of activities to be performed once the data is filled into a template to ensure data type, size, and format of data is as per specifications. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Sr. No.
Checklist Parameter
Example
2
UOM should same for all the values provided pipe size in the template
E.g. If it is given as Inches then it should be inches for all.
Entity Specific Checklist
A separate entity-specific checklist is not needed for this module data.
Attachments
Configuration Data Templateconfiguration-data-template-pipe-size-types.xlsx - 10KB
Sample Datasample-configuration-data-pipe-size-types.xlsx - 9KB
Last updated
