Pipe Size Types

Introduction

Water pipes are available in different sizes. Pipe size is a common parameter used for calculating water charges. The allotted pipe size for new water connections depends on specific service requirements.

Data Table

Sr. No.	Pipe Size*	UOM*
1	0.25	Inches
2	0.50	Inches

Data given in the table is sample data for reference.

Procedure

Data Definition

Sr. No.	Column Name	Data Type	Data Size	Mandatory	Description
1	Pipe size	Decimal	(2,2)	Mandatory	Value for Pipe size
2	UOM	Text	256	Mandatory	Unit of measurement for the pipe size value

Steps to fill data

1. Download the data template attached to this page.

2. Refer to the ‘Data Definition’ section of this document to understand the headers in the template sheet, their data type, size, and definitions.

3. Reach out the person who shared the template for further details or to clear your doubts. Identify if the State/ULB has a provision for capturing pipe size for connections.

4. Enter the Pipe Size details.

5. Enter the corresponding UOM for the specified Pipe Size.

6. Go through the checklist to verify the data. Make sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed once the data is filled into a template to ensure data type, size, and format of data is as per specifications. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Sr. No.	Checklist Parameter	Example
1	Make sure that each and every point in this reference list has been taken care of	Checklist
2	UOM should same for all the values provided pipe size in the template	E.g. If it is given as Inches then it should be inches for all.

Entity Specific Checklist

A separate entity-specific checklist is not needed for this module data.

Attachments

10KB

configuration-data-template-pipe-size-types.xlsx

9KB

sample-configuration-data-pipe-size-types.xlsx