Unit Rates
Introduction
Unit rates are also an important part of property tax. The property tax for a property is calculated on the area covered by the property. These unit rates could differ from ULB to ULB, Ward to Ward, Mohalla to Mohalla and then can be based on different parameters such as Road Type, Property Construction Type etc.
Data Table
1
M001
Haldwani Mandir
PUCCA
< 12 m
1.50
2
M001
Haldwani Mandir
SEMIPUCCA
>= 12 m and <= 24 m
1.75
3
M001
Haldwani Mandir
KUCCHA
> 24 m
2.00
4
M002
Kali Mata Mandir Road
SEMIPUCCA
< 12 m
3.00
5
M002
Kali Mata Mandir Road
SEMIPUCCA
>= 12 m and <= 24 m
10.00
6
M002
Kali Mata Mandir Road
SEMIPUCCA
> 24 m
20.00
The data given in the table is sample data.
Procedure
Data Definition
1
Boundary Code
Alphanumeric
64
Yes
The code of the boundary that is being used, depending upon the client's requirement it could be Mohalla or Ward but has to be from the data collected here
2
Boundary Name (In English)
Text
256
Yes
The name/description of the boundary that is being used for the classification. The names have to be from the data collected here
3
Parameter 1
Alphanumeric
64
Yes
This has to be the parameter 1 code on the basis of which the unit rates are being defined
4
Parameter 2
Alphanumeric
64
No
This is the second parameter(if available) on the basis of which the unit rates are being defined
5
Unit rates
Decimal
(5,2)
Yes
The unit rate
Steps to fill the data
Download the data template attached to this page.
Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.
In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.
Figure out on what boundary types are the property tax unit rates being defined and start filling that with its code and its name in English in the boundary code and boundary code name column.
In case there are more parameters on which the unit rates are being classified such as road type, construction type is being classified, start making a different column for the same starting from parameter 1, parameter 2…
Make sure you replace the column name from parameter 1 to the classification on which it is being classified.
At the end fill up the unit rates column.
Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist is a set of activities to be performed once the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Entity Specific Checklist
Not Applicable
Attachments
Configuration Data Templateconfigurable-data-template-property-tax-unit-rate-v1.xlsx - 9KB
Sample Dataconfigurable-sample-data-property-tax-unit-rate-v1.xlsx - 10KB
Last updated
