Sewerage Penalty Rates

Introduction

The penalty is levied on the consumer if the consumer fails to make the payment for the bill raised before a specified due date. The consumer has to make the full payment before the due date to avoid penalty charges. The number of days after which the penalty is applicable should be configurable at the ULB level.

The penalty can be -

1. Fixed amount; or

2. Percentage: In case of percentage, it can be levied on either

   1. Entire bill amount; or

   2. Balance pending when partial payments have been made

Data Table

Sr. No.	*Penalty based on (Bill amount/Balance pending)	*Grace period (days)	Penalty flat amount (Rs)	Penalty (%)
1	Balance Pending	15	40	10

The data given in the table is sample data for reference.

Procedure

Data Definition

Sr. No.	Column Name	Data Type	Data Size	Mandatory	Description
1	Grace period	Integer	2	Yes	After the bill is generated, certain days are provided to the citizen for making the payment
2	Penalty flat amount	Decimal	(3,2)	Yes	If the penalty is not levied on a percentage basis, it is generally a flat fee which is penalty charges amount
3	Penalty based on	Text	64	Yes	The penalty can be a certain percentage of the bill amount or balance pending if partial payments are made against the bill
4	Penalty (%)	Decimal	(3,2)	Yes	The penalty is calculated as a percentage amount based on either Bill amount or Balance pending

Steps to fill data

1. Download the data template attached to this page.

2. Refer to the ‘Data Definition’ section of this document to learn more about the template sheet, data type, size, and definitions.

3. Please reach out to the person who has shared this template with you to discuss and clear your doubts.

4. Enter the applicable value for the Grace Period.

5. Enter the corresponding Penalty Flat Amount.

6. Select the relevant parameter for Penalty Based On to specify if the calculation of the penalty is based on the bill amount or the pending balance.

7. Enter the applicable percentage value for calculating the Penalty amount.

8. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist contains a set of activities to be performed once the data is filled into a template to ensure data entry requirements are met. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Sr. No.	Checklist Parameter	Example
1	Make sure that each and every point in this reference list has been taken care of	​Checklist​

Entity Specific Checklist

Separate Entity Specific Checklist is not required for this module data.

Attachments

10KB

Configuration data template - Penalty rates (1).xlsx

9KB

Sample configuration data - Penalty rates (1).xlsx

All content on this page by eGov Foundation is licensed under a Creative Commons Attribution 4.0 International License.